IMPORTANT |
Due to extensions on the provider side, a connection can only be made from SwyxWare 12.00 and a correspondingly adapted profile. The use with an older SwyxWare version and the integrated profile is therefore no longer possible. |
The SIP trunk of A1 Telekom was first tested and released with SwyxWare 12.00.
The SIP trunk of A1 Telekom is a SIP trunk with user authentication, i.e. you get information about user ID, user name and password from A1 Telekom. The names may differ, or you will only receive a name or ID with password. In this case the user ID is identical to the user name when configuring the SIP trunk in SwyxWare.
Platforms
SwyxWare
The SIP Trunk of A1 Telekom can be used without restrictions from SwyxWare 12.00. When using an earlier version of SwyxWare incompatibilities cannot be excluded and use is at your own risk.
SwyxON
The SIP Trunk of A1 Telekom is not suitable for central connection in the data center due to the dependency from the internet access.
Configuration
IMPORTANT |
Currently, the required profile must be imported via the CustomProviderProfiles.config. The profile will then be available under the name 'A1 Telekom New (AT)'. |
When creating the actual SIP trunk, a SIP URI must be entered after configuration of the phone number range so that incoming calls can be assigned. The assigned number block must be taken into account in the correct format.
Example:
Number block: +43 1239988776600 ... +43 1239988776699
In this case, the SIP URI must be entered in the format +4312399887766*@*.
When creating the actual SIP trunk, all audio codecs except G.711 can be deselected in the codec dialog. T.38 has to be deselected as supported codec.
Tested Features
- Incoming/outgoing national calls
- Correct Calling Line Identification (CLI) on national and calls
- CLIP No Screening in accordance with RFC3325
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Conferencing
- Mutually supported codecs: G.711a
- Incoming/outgoing DTMF signaling in accordance with via RFC2833
- FAX transmission via G.711a
Restrictions:
-
Test date:
07/09/2018 with SwyxWare 11.20.2.0
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.
Comments
0 comments
Please sign in to leave a comment.