SIP Provider UPC Cablecom, Registered (CH)

General

The UPC Cablecom SIP Trunk with registration was first tested and released with SwyxWare 12.20.0.0.

The UPC Cablecom SIP Trunk with registration is a SIP Trunk with user authentication, i.e. you receive information on user ID, user name and password. The names may differ, or you may only receive a name or ID with password. In this case the user ID is identical to the user name when configuring the SIP trunk in SwyxWare.

Platforms 

SwyxWare
The UPC Cablecom SIP Trunk with registration can be used from SwyxWare 12.20.0.0 on.

SwyxON
The UPC Cablecom SIP Trunk with registration is released for central connection in the data center.

Configuration 

Codec Configuration

During creation of the actual trunk, in the codec configuration dialog, T.38 has to be deselected as supported codec. This step could also be performed afterwards in the properties of the SIP trunk, underneath the 'Codecs' tab.

CLIP No Screening

To activate the feature CLIP No screening in the SwyxWare, it is necessary to set the option "Always use originator's number" in the tab "Number signalling" of the SIP trunk settings.

• Incoming/outgoing national calls
• Correct Calling Line Identification (CLI) on national calls
• Holding and retrieving calls
• CLIP-No-Screening only on national calls
• Toggeling between two calls
• Call transfer
• Conferencing
• Mutually supported codecs: G.711a/ G.711u
• Incoming/outgoing DTMF signaling in accordance with via RFC2833
• FAX transmission via G.711

Restrictions

None

Test date

16/05/2024 with SwyxWare 14.00
16/06/2023 with SwyxWare 13.27
01/11/2020 with SwyxWare 12.20.0.0

Disclaimer

Verifying interoperability between different SIP providers and the Swyx solution is part of the Enreach Technology Alliance Programme (TAP) tasks. Due to different implementations of the SIP RFCs, it is necessary to determine and provide an individual configuration for each SIP provider.

Within the TAP, Enreach tests a large number of national and international SIP providers in order to make statements about the interoperability with the Swyx solution and the functional scope of the respective SIP trunk. These results and, if needed, configuration advice are published in Help Center articles.

Enreach is in close contact with selected SIP providers to ensure a quick troubleshooting in case of incompatibilities. In addition, tests are repeated at regular intervals to ensure consistent quality.

Despite regular retests it cannot be excluded that incompatibilities with the Swyx solution may occur due to changes in the SIP connection on the provider side or that the provided profile is no longer valid. After creating the trunk group or SIP trunk, the profile settings should be compared with the provider's information and adjusted accordingly in case of deviations.

However, should incompatibilities or problems occur with a tested SIP trunk, no claims for recourse against Enreach GmbH can be derived from this. In such cases, you can contact Enreach Support via your specialist dealer.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.