British Telecom (BT) is offering registerless SIP trunks. This means that the authentication is based on the public IP address of the SwyxWare server. Therefore, you need a static, public IP address from your ISP assigned to the SwyxWare server.
BT is operating with a number of different servers. Therefore it is not possible to preconfigure the Proxy Server in the "SIP" tab of the Trunkgroup Properties dialog. In this field, please enter the IP address that BT has named you.
Important: From SwyxWare2015R4 on, the provider profile for British Telecom (UK) is available in the list of provider profiles and the CustomProviderProfiles.config is no longer necessary.
During creation of the SIP Trunkgroup, the profile 'British Telecom (UK)' must be selected.
In case that the SwyxWare server is running with a private IP address and the static, public IP address is provided by NAT gateway, it is necessary to configure a STUN server in the properties of the SIP trunk group, under the tab 'SIP'. A list of public STUN servers can e.g. be found at http://www.voip-info.org/wiki/view/STUN. In this case, it is necessary to configure the correct portwarding in the NAT gateway, such that inbound SIP requests are being forwarded to port 65002 of the SwyxWare server.
If no NAT gateway is necessary, the BT SIP trunk has to be configured such that inbound SIP requests are being directly sent to port 65002 of the SwyxWare server.
For additional information, it is possible to download a configuration guide at the end of this article.
BT expects a Session interval of 600 (seconds) on outbound calls. The prevent reINVITES which would slow down the call establishment, underneath the registry key HKLM\Software\Wow6432Node\Swyx\LinkMgr\CurrentVersion\Options two new DWORD values SipMinSessionTimerIntervalSeconds and SipSessionTimerIntervalSeconds can be created with an assigned value of 600 (decimal). After creating this value, the LinkMgr service must be restarted.
Important: This setting will affect all SIP Trunks.
- Incoming/outgoing national calls
- Correct Calling Line Identification (CLI) on national
- CLIP No Screening
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Mutually supported codecs: G.711a/ G.711µ/ G.729/ T.38 for FAX negotiation
- Incoming/outgoing DTMF signaling in accordance with via RFC2833
- T.38 Negotiation and FAX transmission
21/01/2016 with SwyxWareV2015R3
ConfigurationGuide British Telecom (UK)
CustomProviderProfiles British Telecom (UK)
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.