SIP Provider Vodafone R.6 (DE)

General

The Vodafone IP Anlagen Anschluss (R.6) was first tested and released with SwyxWare 14.00.

The Vodafone IP Anlagen Anschluss (R.6) is available as a SIP Trunk without registration (Static Mode) and as a SIP Trunk with registration (Registration Mode). This article refers exclusively to the SIP trunk with registration.

You will receive information from Vodafone about the UserID, UserName and UserPassword, although the names may differ or you may only receive the user name and password. In this case, the UserID is identical to the UserName.

Platforms

SwyxWare

The Vodafone IP Anlagen Anschluss (R.6) in registration mode can be used with SwyxWare 14.00 or higher. If an earlier version of SwyxWare is used, incompatibilities cannot be ruled out and use is at your own risk.

SwyxON

The Vodafone IP Anlagen Anschluss (R.6) is released for operation in data centers.

Configuration

During creation of the SIP Trunkgroup, profile 'Vodafone IP-AA-R.6 (DE)' has to be selected. If the profile is not included in the corresponding list, you can download the required CustomProviderProfiles.config for SwyxWare at the end of this article. For more information about using this file, see Configuration and Adaptation of SIP Providers via Provider Profiles.

Codec Configuration

In the codec dialog for FAX transmission via T.38 the two options "Remove T.38 codec from initial invite" and "Prohibit T.38 reinvite by sender" must be activated.

CLIP No Screening

To activate the feature CLIP No screening in the SwyxWare, it is necessary to set the option "Always use originator's number" in the tab "Number signalling" of the SIP trunk settings.

Tested features

• Incoming/outgoing national calls
• Incoming/outgoing international calls
• Correct Calling Line Identification (CLI) on national and international calls
• CLIP No Screening
• Holding and retrieving calls
• Toggeling between two calls
• Call transfer
• Conferencing
• Mutually supported codec:
  • G.722
  • G.711a
• Incoming/outgoing DTMF signaling in accordance with via RFC2833
• FAX transmission via T.38

Limitations

Number supression does not work

Tests

Disclaimer

Verifying interoperability between different SIP providers and the Swyx solution is part of the Enreach Technology Alliance Programme (TAP) tasks. Due to different implementations of the SIP RFCs, it is necessary to determine and provide an individual configuration for each SIP provider.

Within the TAP, Enreach tests a large number of national and international SIP providers in order to make statements about the interoperability with the Swyx solution and the functional scope of the respective SIP trunk. These results and, if needed, configuration advice are published in Help Center articles.

Enreach is in close contact with selected SIP providers to ensure a quick troubleshooting in case of incompatibilities. In addition, tests are repeated at regular intervals to ensure consistent quality.

Despite regular retests it cannot be excluded that incompatibilities with the Swyx solution may occur due to changes in the SIP connection on the provider side or that the provided profile is no longer valid. After creating the trunk group or SIP trunk, the profile settings should be compared with the provider's information and adjusted accordingly in case of deviations.

However, should incompatibilities or problems occur with a tested SIP trunk, no claims for recourse against Enreach GmbH can be derived from this. In such cases, you can contact Enreach Support via your specialist dealer.

The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.