The SIP Trunk from Equada was first testet and released with a SwyxWare 2015R3.
Equada is offering a SIP trunk with user authentication. You have received information about UserID, UserName and UserPassword, whereas the naming may differ, or you might have only received UserName and -password. In this case, UserID and UserName are identical. Additionally you will receive an individual SIP Registration domain.
The actual interoperability tests were executed by equada itself, not by the Enreach TAP.
The SIP Trunk from Equada can be used according to the settings listed below from SwyxWare 13.10 on. If you use an earlier version of SwyxWare, incompatibilities cannot be excluded and you are responsible for your own usage.
The SIP Trunk from Equada is not released for central connection in the data center.
During creation of the SIP Trunkgroup, profile 'equada GmbH (DE)' must be selected.
The information about the SIP Registration domain must be entered into the field "Realm" in the "SIP" tab of the Trunkgroup properties.
- Incoming/outgoing national calls
- Incoming/outgoing international calls
- Correct Calling Line Identificaion (CLI) on national and international calls
- CLIP No Screening
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Mutually supported codecs:
- T.38 for FAX transmission
- Incoming/outgoing DTMF signaling in accordance with via RFC2833
- T.38 Negotiation and FAX transmission
17/12/2015 with SwyxWare2015R3
Verifying interoperability between different SIP providers and the Swyx solution is part of the Enreach Technology Alliance Programme (TAP) tasks. Due to different implementations of the SIP RFCs, it is necessary to determine and provide an individual configuration for each SIP provider.
Within the TAP, Enreach tests a large number of national and international SIP providers in order to make statements about the interoperability with the Swyx solution and the functional scope of the respective SIP trunk. These results and, if needed, configuration advice are published in Help Center articles.
Enreach is in close contact with selected SIP providers to ensure a quick troubleshooting in case of incompatibilities. In addition, tests are repeated at regular intervals to ensure consistent quality.
Despite regular retests it cannot be excluded that incompatibilities with the Swyx solution may occur due to changes in the SIP connection on the provider side or that the provided profile is no longer valid. After creating the trunk group or SIP trunk, the profile settings should be compared with the provider's information and adjusted accordingly in case of deviations.
However, should incompatibilities or problems occur with a tested SIP trunk, no claims for recourse against Enreach GmbH can be derived from this. In such cases, you can contact Enreach Support via your specialist dealer.
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.
Please sign in to leave a comment.