The SIP Trunk from SKYTRON was first tested and released with SwyxWare 220.127.116.11.
The SIP Trunk from SKYTRON is a SIP Trunk with user authentication, i.e. you receive information on user ID, user name and password. The names may differ, or you may only receive a name or ID with password. In this case the user ID is identical to the user name when configuring the SIP trunk in SwyxWare.
The SIP Trunk from SKYTRON can be used from SwyxWare 18.104.22.168 on. When using an earlier version of SwyxWare incompatibilities cannot be excluded and use is at your own risk.
The SIP Trunk from SKYTRON is suitable for central connection in the data center.
When creating the SIP trunk group, select the profile 'SKYTRON (DE)'. If the profile is not included in the corresponding list, you can download the required CustomProviderProfiles.config for SwyxWare at the end of this article. For more information about using this file, see Configuration and Adaptation of SIP Providers via Provider Profiles.
In order to assign incoming calls to the correct trunk, it is necessary to configure a SIP URI for the trunk. The assigned number block and the numberformat must be considered.
Numberblock: +41 40 123456780 ... +41 40 123456789
In this case, the SIP URI must be entered in the format +494012345678*@*.
Afterwards, the LinkMgr service has to be restarted.
- Incoming/outgoing national /international calls
- Correct Calling Line Identification (CLI) on national / intenational calls
- CLIP No Screening
- Holding and retrieving calls
- Toggeling between two calls
- Call transfer
- Call forwarding
- Mutually supported codecs: G.722, G.711A, G.722u, G.729
- Incoming/outgoing DTMF signaling in accordance with via SIP INFO
- FAX transmission via T.38
Number suppression currently does not work
18/06/2020 with SwyxWare 22.214.171.124
Verifying interoperability between different SIP providers and the Swyx solution is part of the Enreach Technology Alliance Programme (TAP) tasks. Due to different implementations of the SIP RFCs, it is necessary to determine and provide an individual configuration for each SIP provider.
Within the TAP, Enreach tests a large number of national and international SIP providers in order to make statements about the interoperability with the Swyx solution and the functional scope of the respective SIP trunk. These results and, if needed, configuration advice are published in Help Center articles.
Enreach is in close contact with selected SIP providers to ensure a quick troubleshooting in case of incompatibilities. In addition, tests are repeated at regular intervals to ensure consistent quality.
Despite regular retests it cannot be excluded that incompatibilities with the Swyx solution may occur due to changes in the SIP connection on the provider side or that the provided profile is no longer valid. After creating the trunk group or SIP trunk, the profile settings should be compared with the provider's information and adjusted accordingly in case of deviations.
However, should incompatibilities or problems occur with a tested SIP trunk, no claims for recourse against Enreach GmbH can be derived from this. In such cases, you can contact Enreach Support via your specialist dealer.
The third-party contact information included in this article is provided to help you find the technical support you need. This contact information is subject to change without notice. Swyx in no way guarantees the accuracy of this third-party contact information nor is responsible for it's content.
Please sign in to leave a comment.