The information in this article applies to the following products:
- Enreach DECT BS 600 S
- Enreach DECT BS 600 L
- Enreach DECT BS 600 Outdoor
- Enreach DECT HS 6x0
- Enreach DECT R 600 Repeater
- SwyxPhone D510
- SwyxPhone D565
Version 6.10.B101 of this firmware package is identical to the version of the Enreach DECT 600 S/L system as delivered.
The Enreach DECT 600 Firmware Compatibility Pack (v6.10.B101) is however required if existing SwyxPhone D510/D565 or a DECT BS 600 Outdoor base are to be connected to a new Enreach DECT 600 S/L system.
The Firmware Compatibility Pack can be found in the Enreach Partnernet: Enreach DECT 600 Firmware Download and will be available within the next day.
With the release of the new Enreach DECT 600 Multicell systems the update of the proven SwyxDECT 500 is available. More information about the product update can be found here.
At the time of the product launch in spring 2022, the firmware version 6.10.B101 corresponds to the delivery status of the Enreach DECT 600 components. An update of a newly installed DECT 600 system should therefore not be necessary as a rule.
Attention: Version B101 only applies to the base stations - handsets and repeaters are delivered with version B01 and remain on this version.
Under certain conditions SwyxDECT 500 and Enreach DECT 600 components can be operated in a hybrid installation. The requirements for such mixed installations are described in detail here.
For the operation of SwyxPhone D510/565 on an Enreach DECT 600 installation the handsets have to be updated to the latest firmware v6.10.B01. The required firmware is part of the Enreach DECT 600 Firmware Compatibility Pack (v.6.10.B101).
Another exception are the Enreach DECT BS 600 Outdoor bases: Due to the low quantities, these devices are not produced with the Enreach FW, but with a generic, non-OEMised FW. To use these bases with an Enreach DECT 600 L system, they must be updated to firmware v6.10.B101.
Important note: The Firmware Compatibility Pack (v6.10.B101) is not compatible with SwyxDECT 500 infrastructure components (base, repeater).
Installation note: Differing from the SwyxDECT 500 the paths in the firmware archive have been changed for a better differentiation. Copy the decompressed firmware packages including the stored paths to your update server and then adjust the path in the Enreach DECT 600 administration accordingly.
If you only want to update/downgrade individual devices, this can be done during operation. However, if you want to update the entire system to v6.10.B101, follow the instructions for using a maintenance window in the release notes.